Aerial work platforms tires

Aerial work platforms are products that serve mobile work at heights in various industries, such as high-altitude operations, equipment installation, and maintenance.
The related products of aerial work platform mainly include: scissor aerial work platform, trailer aerial work platform, crank arm aerial work platform, straight arm aerial work platform, aluminum alloy aerial work platform, sleeve-cylinder aerial work platform, spider type Seven categories of aerial work platforms.

friendway series of aerial work platform tires were designed to meet the needs of today’s job site demands. We came up with a way to offer you serviceability, traction and a comfortable ride all in one!

A lot is riding on your aerial work platform (AWP) tires. They are the vital link between the machine and the ground providing the traction, stability, flotation and machine control required for operating safely. Tires get you to where you want to go, both non-marking that leave no traces behind and treaded to traverse rough terrain.

The nature of where these machines operate — from congested construction sites to rough outdoor terrain — can lead to tire damage, which requires close attention and frequent inspection.

Following the inspection and replacement requirements in the friendway® AWP Manuals will help give you the confidence that your lift will take you where you need to be:

Tire type…

First and foremost, know what type of tires are on your lift. Certain lifts come standard with solid hard-rubber non-marking tires, whereas a rough-terrain lift could be equipped with one of several tire types: Solid non-marking, lug pattern (foam- or air-filled) or high flotation (foam- or air-filled).
Inspection tips…

Inspect tires for damage to the tread area and sidewalls (cuts, tears, missing chunks, etc.). If there is any damage to the tire, it should be replaced.
Inspect solid rubber tires. Ensure the solid tire is completely bonded to the rim. If there are any signs of tire separation from the rim, the tire should be replaced.
Ensure a static strap is installed on the machine when inspecting units with non-marking tires. When the carbon is removed from the non-marking tire (gray or white), a static charge build-up occurs. The static strap will dissipate this charge to help protect onboard electronics.
Tire Talk: Inspection and Replacement Tips for Aerial Work Platform TiresTire replacement…

Replace with like tires. Tires provide a part of the machine’s stability and offer traction. Replacing with like tires approved by Friendway, or the manufacturer of your unit, maintains the machine’s designed stability. It is important to note that foam-filled and air-filled tires must be replaced with like tires. Never mix foam-filled and air-filled tires on the same unit.
Not all foams are created equal. Not just any foam will work, and your service technician should check with Genie, or the manufacturer of your unit, to ensure that the right type of foam is used.
One parting tip related to your tires: Make sure the lug nuts are properly torqued prior to sending the unit out on a jobsite. The lug nuts should be torqued whenever a tire is replaced or during the scheduled annual inspection.

Like this article?

Share on facebook
Share on Facebook
Share on twitter
Share on Twitter
Share on linkedin
Share on Linkdin
Share on pinterest
Share on Pinterest

Leave a comment

en_USEnglish